PLANET WNAP-1260 - Manual (Page 102)

User’s Manual of WNAP-1260
-94-
Object Description
 Enable Port
Triggering:
If Enable Port Triggering box is not checked, all port triggering
function will be disabled
 Port Triggering
Timeout:
The timeout value controls the inactive timer at the specified ingress
port. Upon timeout of the inactive timer, the ingress port is disabled
Click the Add Service button and the Port Triggering – Services page is displayed:
Figure 8-36
Object Description
 Service Name: Enter a service name
 Service User:
 Any: Allow everybody in the user network to use the service.
 Single address: Enter the IP address of the network adapter
on the PC. Then, the service is applied only on the specific
network adapter of the PC.
 Service Type:
The protocol used at the triggering port. You can select TCP/UDP,
TCP, or UDP
 Triggering Starting
Port:
The first port to which an application sends a connection request. All
relevant ports can be open only after connection is established at
this starting port. Otherwise, other relevant ports are not open.
 Triggering Ending
Port:
Set the end port of the triggering port range.
 Starting Port: The starting port of the port range
 Ending Port: The ending port of the port range.
After finishing settings, click Apply to add a port triggering rule.