PLANET GSD-1002M - Manual (Page 19)

User’s Manual of GSD-1002M
2. INSTALLATION
This section describes the hardware features and installation of the Managed Switch on the desktop or rack mount. For easier
management and control of the Managed Switch, familiarize yourself with its display indicators, and ports. Front panel
illustrations in this chapter display the unit LED indicators. Before connecting any network device to the Managed Switch, please
read this chapter completely.
2.1 Hardware Description
2.1.1 Switch Front Panel
The front panel provides a simple interface monitoring the Managed Switch. Figure 2-1 shows the front panel of the Managed
Switch.
Front Panel
Figure 2-1 GSD-1002M front panel
■
SFP transceiver module: From 550 meters (Multi-mode fiber), up to 10/30/50/70/120 kilometers
transceiver module: From 2 kilometers (Multi-mode fiber), up to 20/40/60 kilometers
(Single-mode fiber).
■
g the Managed Switch without turning off and on
the power. The following is the summary table of Reset button functions :
100/1000Base-X SFP Slots
Each of the SFP (Small Form-factor Pluggable) slot supports Dual-speed, 1000Base-SX / LX or 100Base-FX
- For 1000Base-SX/LX
(Single-mode fiber).
- For 100Base-FX SFP
Reset Button
On the left side of the front panel, the reset button is designed for rebootin
Reset Button Pressed and Released Function
< 5 sec: System Reboot Reboot the Managed Switch.
> 5 sec: Factory Default
.
hen reboot and load the default
Reset the Managed Switch to Factory Default configuration
The Managed Switch will t
settings as shown below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
19