PLANET FNSW-2400PS - Manual (Page 12)

User’s Manual of FNSW-2400PS
2.3.2 Rack Mounting
To install the POE Web Smart Ethernet Switch in a 19-inch standard rack, follow the instructions described below.
Step 1 : Place your POE Web Smart Ethernet Switch on a hard flat surface, with the front panel positioned towards your
front side.
Step 2 : Attach a rack-mount bracket to each side of the POE Web Smart Ethernet Switch with supplied screws attached to
the package. Figure 2-3 shows how to attach brackets to one side of the POE Web Smart Ethernet Switch.
Figure 2-3 Attaching the brackets to the POE Web Smart Ethernet Switch
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
using incorrect screws would invalidate your warranty.
Step 3 : Secure the brackets tightly.
Step 4 : Follow the same steps to attach the second bracket to the opposite side.
Step 5 : After the brackets are attached to the POE Web Smart Ethernet Switch, use suitable screws to securely attach the
brackets to the rack, as shown in Figure 2-4 .
- 12 -