PLANET FNSW-2400PS - Manual (Page 11)

User’s Manual of FNSW-2400PS
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the
time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data
loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your POE Web Smart Ethernet Switch
from being damaged by unregulated surge or current to the POE Web Smart Ethernet Switch.
2.3 Hardware Installation
This part describes how to install your POE Web Smart Ethernet Switch and make connections to the Switch. Please read
the following topics and perform the procedures in the order being presented. To install your POE Web Smart Ethernet
Switch on a desktop or shelf, simply completed the following steps.
2.3.1 Desktop Installation
To install POE Web Smart Ethernet Switch on a desktop or shelf, simply completed the following steps:
Step 1 : Attached the rubber feet to the recessed areas on the bottom of the POE Web Smart Ethernet Switch.
Step 2 : Place the POE Web Smart Ethernet Switch on a desktop or shelf near an AC power source.
Step 3 : Keep enough ventilation space between the POE Web Smart Ethernet Switch and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions discussed in Chapter
1, Section 4, Specification.
Step 4 : Connect your Switch to network devices.
A. Connect one end of a standard network cable to the 10/100 RJ-45 ports on the front of the POE Web Smart Ethernet
Switch.
B. Connect the other end of the cable to the network devices such as printer servers, workstations or routers…etc.
Connection to the POE Web Smart Ethernet Switch requires UTP Category 5 or above cabling with
RJ-45 tips. For more information, please see the Cabling Specification in Appendix A.
Step 5 : Supply power to the POE Web Smart Ethernet Switch.
A. Connect one end of the power cable to the POE Web Smart Ethernet Switch.
B. Connect the power plug of the power cable to a standard wall outlet then power on the POE Web Smart Ethernet
Switch.
When the POE Web Smart Ethernet Switch receives power, the Power LED should remain solid Green.
- 11 -