Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 - Manual (Page 93)

Overview
DFE-Platinum Series Hardware Installation Guide C-3
PoE Port Status LEDs
The PoE port status of each 10/100/1000 Mbps front‐panel port is indicated by the
two‐color RX and TX LED display for each port. To observe the PoE port status
indications, you must switch the DFE module management system from the default RX/
TX Status Mode to the PoE Port Status Mode using the DFE module front‐panel GROUP
SELECT switch. The switch operation and a description of how to use the LED indications
are described in “
Using LANVIEW ” on page 4‐1.
Table C‐2 provides a brief description of each port status RX/TX LED display.
Table C-2 PoE Status LED Indications
PoE Port Status RX LED TX LED
Port is powered on Green Off
Port is off due to overload Off Red
Port is off due to power management Red Off
Port is off for other reason Off Off