Reinstalling the safety cover – Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 User Manual
Page 88
Gaining Access to Memory Modules
B-14 Mode Switch Settings and Option Installations
Reinstalling the Safety Cover
To install the safety cover, refer to
and proceed as follows:
1.
Locate the seven screws saved in the procedure “
2.
Fasten the safety cover to the standoffs using the seven screws. This completes the
safety cover installation.
Warning: The safety cover protects you from exposure to an energy hazard in excess of
240 Volt-Amperes. Never operate the DFE module without the safety cover installed.
Advertencia: La cubierta de seguridad lo protege de exponerlo al riesgo de energía en
exceso de 240 Volt -Amperes.Nunca se debe opererar el modulo de DFE sin la cobertura
de seguridad instalada.
Warnhinweis: Die Sicherheitsabdeckung schützt vor Stromstössen von bis zu 240 VA.
Bitte nehmen Sie niemals die DFE Module ohne die Abdeckung in Betrieb.