Dimm replacement procedure, Dimm, Replacement procedure – Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 User Manual
Page 84: Figure b‐6
Gaining Access to Memory Modules
B-10 Mode Switch Settings and Option Installations
4.
Reinstall the safety cover. Refer to “
” on page B‐14 for
instructions.
Figure B-6 Installing the DIMM
DIMM Replacement Procedure
In the event that the DIMM needs to be replaced, the following sections explain how to
remove and install the SIMM. If you have questions concerning the replacement of the
SIMM, refer to “
” on page xviii for details on how to contact
Enterasys Networks.
Removing the DIMM
To remove the existing DIMM, proceed as follows:
1.
Remove and save the seven screws attaching the safety cover to the standoffs on the
main PC board.
2.
Locate the DIMM connector on the main PC board. Refer back to
for the
DIMM location on the 7G4285‐49.
1 Connector arms
3 Connector fingers
2 DIMM
4 DIMM alignment notches (2)
В
А
А
Б
Г
Г
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.