Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 - Manual (Page 33)

DFE-Platinum Series Hardware Installation Guide 3-1
3
Installation
This chapter provides the instructions to install the 7G4285‐49 and 7G4205‐72
DFE modules. Follow the order of the sections listed below to correctly install the
DFE modules.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE modules to check for any exceptions to the
supported features and operation documented in this guide.
For information about... Refer to page...
Installation Site Requirement 3-2
Required Tools 3-2
Unpacking the DFE Module 3-2
Installing an Optional Network Expansion Module (NEM) 3-3
DFE Module Placement and Installation Rules 3-3
Preparing to Install into a Chassis 3-6
Connecting 48 Vdc Power for PoE Operation 3-12
Connecting to the Network 3-12
Connecting to COM Port for Local Management 3-18
Completing the Installation 3-24