Viewing the poe port status, Viewing the poe port status -4 – Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 User Manual
Page 62

Using LANVIEW
4-4 Troubleshooting
Viewing the PoE Port Status
If the 7G4285‐49 or 7G4205‐72 is installed in an N5 chassis or if the 7G4285‐49 is receiving
48 Vdc from an external N‐POE Power System to support connections to PDs (Powered
Devices), you can view the power status indications on the RX and TX LEDs. However,
only one group of 12 ports may be viewed at a time. To view the PoE port status, refer to
1.
Press the GROUP SELECT button for more than one second. The DFE module will
enter the PoE port status mode.
2.
Now, every time you press the GROUP SELECT button for less than a second, the
GROUP LED lights up in sequence, indicating which Group is selected. The PoE
POWER STATUS for that group of segments is then indicated by the RX and TX LEDs
for each segment. If there is power at the port, the RX LED is green and the TX LED is
off. Otherwise, refer to
for troubleshooting information.
3.
Press the GROUP SELECT button again for more than one second. This returns the
DFE module to the default status mode to monitor RX (receive) and TX (transmit)
activity.
on page 4‐5 describes the LED indications and provides recommended actions
as appropriate.
Note: The terms used in
• Flashing indicates LED is flashing randomly.
• Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).
• Solid indicates a steady LED light. No pulsing.
• Alternating indicates LED is flashing in a steady rate other than 50% on, 50% off.