Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 - Manual (Page 52)

Connecting to COM Port for Local Management
3-20 Installation
3. Connect the RJ45‐to‐DB25 adapter to the port labeled COMM on the VT terminal.
4. Turn on the terminal to access the Setup Directory and set the following parameters:
When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix DFE‐Platinum Series Configuration Guide for further
information.
Figure 3-10 Connecting a VT Series Terminal
Connecting to a Modem
To connect a modem to an Enterasys Networks DFE modules COM port ( Figure 3‐11 ), use
a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25 male adapter,
and proceed as follows:
1. Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port of the module.
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
1 UTP straight-through cable with RJ45 connectors 3 RJ45-to-DB25 VT adapter
2 RJ45 COM port 4 VT series terminal
В А Г
CPU
POE
1X
G
R
O
U
P
1
OFFLINE/
RESET
COM
MGMT
GROUP
SELECT
GROUP
1
2
3
4
5
6
1
2
3
4
7G4285-49
Gb ENET
Б