Installing the network expansion module (nem), Installing the network expansion, Module (nem) – Enterasys Networks Enterasys Platinum Distributed Forwarding Engine 7G4285-49 User Manual
Page 86: Figure b‐8
Gaining Access to Memory Modules
B-12 Mode Switch Settings and Option Installations
Figure B-8 Installing the DIMM
Installing the Network Expansion Module (NEM)
Refer to
1.
Position the network expansion module so its front panel is under the edge of the
DFE module front panel.
2.
Align the two network expansion module connectors with the main board connectors.
Then press straight down over the two network expansion module connectors,
applying pressure until they are properly seated.
1 DIMM
3 Connector arms
2 Connector fingers
4 Alignment notches (2)
А
Б
В
Г
Г
В
This manual is related to the following products: