KEPCO HSP Series Operator Manual - Manual (Page 15)

HSPSERIES OPR 050614
2-1
SECTION 2 - INSTALLATION
2.1 UNPACKING AND INSPECTION
This instrument has been thoroughly inspected and tested prior to packing and is ready for
operation. After careful unpacking, inspect for shipping damage before attempting to operate.
Perform the preliminary operational check as outlined in PAR. 2.5. If any indication of damage is
found, file an immediate claim with the responsible transport service.
2.2 TERMINATIONS AND CONTROLS
a) Front Panel: Refer to Figure 2-1.
b) Configuration Controls: Refer to Figure 2-2 and Table 2-1.
c) Rear Panel: Refer to Figure 2-3 and Table 2-1.
FIGURE 2-1. HSP SERIES FRONT PANEL CONTROLS AND INDICATORS
FIGURE 2-2. CONFIGURATION SWITCH FUNCTIONS
TABLE 2-1. CONFIGURATION CONTROLS
SW
POSITION
FUNCTION
REF
PAR.
S1-1 REMOTE LOCKOUT RESET 3.12
S1-2 CURRENT WALK-IN 3.10
S1-3 UNDERVOLTAGE LOCKOUT 3.9
S2-1 RANGE SELECT (VOLTAGE LOOP) 3.4
S2-2 RANGE SELECT (FAULT DETECTOR) 3.4
S2-3 EXT. VOLT. PROG. (VOLTAGE LOOP) 3.3
S2-4 EXT. RES. PROG. (VOLTAGE LOOP) 3.3
S2-5 INT. PROG. (VOLTAGE LOOP) 3.3
S3-1 RANGE SELECT (CURRENT LOOP) 3.6
S3-2 EXT. VOLT. PROG. (CURRENT LOOP) 3.5
S3-3 INT. PROG. (CURRENT LOOP) 3.5