KEPCO HSP Series Operator Manual - Manual (Page 13)

HSPSERIES OPR 050614
1-7/(1-8 Blank)
TABLE 1-3. ACCESSORIES
ACCESSORY PART NUMBER USE
RACK
ADAPTERS
RA 58
Provision for three HSP (or HSM) Power Supplies in a 19-inch rack. Used for hard-wired
applications only.
RACK
ADAPTER
OPTIONS
RA 59
Same as RA 60 except accommodates up to four HSP Power Supplies in a 24-inch rack for
plug-in and hot swappable applications.
RA 60
Plug-in rack adapter provides for three HSP Power Supplies in a 19-inch rack. Designed
specifically for hot-swap applications when used with R-suffix HSP models; the power out-
puts of all three positions of this rack adapter are permanently bussed together in parallel.
Separate source power and I/O signal connections for each position.
RA 61
Provision for four HSP (or HSM) Power Supplies in a 24-inch rack. Used for hard-wired appli-
cations only.
RA 62
Same as RA 60 except that two positions are bussed together in parallel while the remaining
position is left isolated for independent operation.
RA 63 Same as RA 60 except that all three positions are isolated for independent operation.
-23E
Incorporates wider mounting ears to accommodate a 23-inch rack; available for all 19-inch
rack adapters above.
-24E
Incorporates wider mounting ears to accommodate a 24-inch rack; available for all 19-inch
rack adapters above.
SERIES
CLAMPING
DIODES
124-0600
Used with HSP 24V, 28V and 48V models when wired for series operation. User must pro-
vide wiring and heat sink. One diode required for each power supply. See PAR.2.7.5.3.
124-0601
Used with HSP 3.3V, 5V, 12V and 15V models when wired for series operation. User must
provide wiring and heat sink. One diode required for each power supply. See PAR. 2.7.5.3.
CONNECTORS
142-0422 I/O connector mating plug
142-0381 Source power inlet connector mating plug (IEC 320-C19)
118-0776 North American linecord set (NEMA 5-20P to IEC 320-C19)
108-0294 I/O connector backshell
108-0203 I/O connector jackposts (set of two)
FIXED
INSTALLATION
KIT
219-0240
Standard - Kit consists of North American linecord set, I/O connector mating plug, I/O con-
nector backshell, I/O connector jackposts, and plastic feet with screws.
219-0249
Customer-wired - Same as Standard Kit (Part No. 219-240), except linecord is replaced with
user-wired AC power inlet mating plug.
SCREW 101-0159 Used to attach plastic feet to HSP Power Supply (#6-20, 0.625 in. long).