TA Triumph-Adler DC 2325 - Manual (Page 206)

Troubleshooting
6-26 OPERATION GUIDE
5 Remove the jammed original.
If the original tears, remove every loose scrap from inside the machine.
6 Remove the original by turning
the dial C as shown in the
figure.
7 Put paper feed unit A back in its original place and close the document
processor top cover.
8 Reload the originals on the document processor tray.
Optional Document Finisher
If a misfeed occurs in the optional document finisher, refer to the respective
Operation Guides to clear the jam.
Optional Job Separator (optional)
Follow the steps below to clear paper jams in the optional job separator.
1 If jammed paper is seen
through the paper output slot
of the job separator, pull it
toward your side to remove it.
If the paper tears, remove
every loose scrap from inside
the machine.
2 Pull up left cover 1 lever and
open left cover 1.
C