Intg, Intg -14 – RIGOL MSO/DS1000Z Series User Manual

Page 128

RIGOL

Chapter 6 MATH and Measurement

6-14

MSO1000Z/DS1000Z User’s Guide

If source A selects any channel in CH1-CH4, press Thre.A and use

set the

threshold of source A in logic operation. If source A selects any channel in

D0-D15, Thre.A will be hidden automatically.

 Press Offset and use

to adjust the vertical position of the operation results.

 Press Scale and use

to adjust the vertical scale of the operation results.

 Press Scale Reset to adjust the vertical scale of the operation results to the

optimal value according to the current configuration.

 Press Options to set the start and end points of the operation results, enable or

disable waveform invert, etc.
―

Press Start and use

to set the start point of the operation results.

―

Press End and use

to set the end point of the operation results.

―

Press Invert to enable or disable the inverted display function of the

waveform.

―

Press Sens. and use

to set the sensitivity of the digital signal converted

from the analog signal on the source. The setting range is from 0 Div to

0.96 Div.

―

Press Auto Scale to enable or disable the auto scale function. When auto

scale is enabled, the instrument will adjust the vertical scale of the

operation results to the optimal value according to the current

configuration.

―

Press fx Operator, fx A and fx B to set the operator and signal sources of

the inner layer operation of Fx operation (please refer to the introduction in

"Fx Operation").

Note:

Smooth is grayed out and disabled. It is only available for differential

operation.

 You can also use HORIZONTAL POSITION and HORIZONTAL

SCALE to adjust the horizontal position and scale of the operation results.

Intg

Calculate the integral of the selected source. You can use integral to measure the

area under a waveform or the pulse energy.

Press MATH  Math  Operator to select "Intg":
 Press Operation to enable or disable the "Intg" operation function.
 Press Source to select the desired channel (CH1, CH2, CH3, CH4 or fx (please

refer to the introduction in "Fx Operation")).