MINOURA W-150 - Manual (Page 4)

– 4 –
8
Install Foot Pedal on Front Leg.
The pedal can be installed on any side. Choose your favorite side for
installation.
First, remove the srew and the narrow metal collar on the top bracket.
4
1
2
3
9
① Remove the screw from the top bracket.
(already described in Step-8).
② Insert the inner cable into the slit on the End-
Plug Hook. The end-plug must be horizontal to
fit the bracket naturaly.
Attach the outer cable end to the 2nd bracket,
and put the cable into the slot of the 3rd bracket.
③ Tighten the screw and narrow metal collar
again to keep the cable end plug in position.
④ Put Foot Pedal on Front Leg and tighten the
backside knob bolt.
You don't need to tighten the
knob bolt firmly.
How To Install Clamp Jaws
1
Hook the cable end plug to the bracket which controls Gas
Dampener.
The plug should be caught with both sides of bracket.
Placing the plug in the groove is not good.
2
Clamp Jaws
Push down the lever
Flat Washer
Knob Nut
Lock
Release
Hook
Install Clamp Jaws.
Insert the clamp axle from foreside of the stand.
Outer edge of the clamp is designed as dog clutch
gears to fix the clamp at certain angle. This
sometimes disturbs the clamp insertion, so you
should push down the Lock Lever for easier job.
Put a flat washer and Lock Release Hook to the
axle then tighten Knob But.
The hook can set in any direction.
If you have tightened the backside knob nut too
much, the clamp won't rotate smoothly.
The ideal condition is you can rotate the clamp
smoothly without any backlash.
Locking Gear
Axle
Outer Cable Guide
Inner Cable Guide
End-Plug Hook
Attach Outer Cable End Here
Insert Outer
Cable