MINOURA W-150 - Manual (Page 2)

2
3
4
– 2 –
Required Tools: 13mm spanner / 10mm spanner /
Phillips screwdriver / 5mm hex wrench
Recommended: Stool
1
Place W-150 body on the stool, and open the
Support Stay.
Install Front Legs to Support Stays.
M6x50 Bolt should locate outside and
M6 Nylon Nut should locate inside.
Do not forget to install an M6 Flat
Washer between Front Leg and
Support Stay too.
M6x50 Bolt
M6 Nylon Nut
M6 Flat Washer
Support
Stay
To install the legs, remove the Bottom Cover
temporally.
Loosen 4 bolts with 13mm spanner and take the
cover off.
Be sure each bolt has a metal collar and a plastic
shim in the box. Do not miss them.
Bottom
Cover
At first, insert Front Legs to the lower 2 bolts.
There are plastic shims in the deepest position.
Each has a groove on one side.
Understand the leg tube sits in this groove.
Insert the legs deeply until the metal collar
becomes visible from the hole on the leg.
If this insertion is not enough, the total stability
won't be guaranteed.
Make sure the
direction of the
plastic shims
Deeply insert the legs
Assembling W-150