MINOURA W-150 - Manual (Page 3)

– 3 –
5
Install Rear Leg to the upper 2 bolts.
Do not set the leg in the wrong direction or the
overall balance of the stand will be affected
negatively.
There are plastic shims here too. Set them in
proper direction.
6
Once again, make sure all legs are fully
inserted to the collars.
Install Bottom Cover and tighten the bolts
temporally by finger. You don't need to use
tool at this moment.
1
2
7
Deeply insert the
leg until the collars
become visible
Make sure the Rear Leg direction
Flip and stand W-150 on the floor.
① Tighten the M6x50 Bolt which connects
Front Leg and Support Stay first.
Use 10mm spanner and M5 hex wrench.
② Tighten all 4 bolts firmly by 13mm
spanner.
Now assembling W-150 body is completed.
Make sure the
direction of the
plastic shims
Bottom
Cover