Assemble mpt-200s in k-style leg – MINOURA MPT-200S User Manual

Page 2

- 2 -

Assemble MPT-200S in K-style Leg

Bolts stay in loose

Pillar Joint

Setting up your MPT-200S in the K-Style leg configuration saves valuable

room because the stand can be placed next to a wall. ONLY place the

bikes on the front side of the stand so as to maintain balance and keep the

stand from toppling over. Maximum bikes per stand is TWO (2).

Pillar

(Fig. A)

Leg Bracket

(both are exactly

same)

Collar (Silver)

M6x70 Bolt

Spring Washer

Attach two Leg Brackets to the

Pillar.

One is set directly, and another

one is set beyond the silver

Collars.

Do not tighten the M6x70 Bolts

firmly yet. (see Fig. B)

Screw the bolts to
these slots

(Fig. B)

(Fig. C)

Put the black Collars to the designated holes (see Fig. D) on

both Long and Short Legs. Collar is put from the larger hole.

The collar works to prevent deforming the tube

by the bolt tightening power. You must set

the collar correctly.

Long Leg

Collar (Black)

Short Leg

(Fig. D)

Place the legs as shown in Fig.E.

(Fig. E)

Required Tools

1 x M5 Hex Wrench

(included)

1 x Phillips Screwdriver

(not included)

1 x 13mm Spanner

(not included)

(We strongly recommend to use the fatter No.3
screwdriver instead of standard No.2)

How To Read Bolt Size

Length

Diameter

Ex) 6 x 30

Diameter Length

Foot Adjuster

Short Leg

Long Leg

Lower Pillar

Upper Pillar

Part Name