MINOURA BikeTower10 - Manual (Page 4)

- 4 -
How To Mount Your Bike
To mount your bike on BikeTower, place the hooks
under the crossing sections of the frame tubing.
Normally, you will hook the top-tube with both
hooks, but in the case of sloping frame, you can
change to another point such as behind the seat-
tube.
Choose the most stable section for maximum safety.
!
If your bike has been to have the front
wheel higher than the rear wheel, the
front wheel may move side-to-side.
This could cause incidental damage to
your bike if the handle bars or brakes
or other parts come in contact with
your frame.
Adjust the bike accordingly to avoid
incidental contact.
How To Re-Install Clamp Band
The clamp bands come pre-installed and they
should not need to be removed. However, there may
come time when adding options to BikeTower that
you will need to remove them.
The band direction is absolutely fixed. You must
install the clamp band in proper direction.
Failure to do so will cause serious trouble that the
bike will slide down or the parts will be damaged.
1
2
3
Stand to the front of the
pillar first, wind Clamp
Arms around the pillar.
Make sure the single side
arm is on YOUR right, and
the double side arm is on
YOUR left.
Put Pivot Pin through all 3
holes on the clamp band from
bottom side, and screw Pivot-Pin
Fixing Bolt with a flat washer
temporally.
!
Make sure to insert
Pivot Pin from the
bottom. If you don't,
you will not be able to
tighten the bolt using a
hex wrench.
When installing the
clamp band to the
smaller diameter Top
Pillar, you must put
Plastic Shim between
the band and pillar as
a spacer.
Make sure the dual
ribs are located on the
single arm side.
!
Bottom Pillar
(larger
diameter)
Top Pillar
(smaller
diameter)
Put the Shim
Turn Pivot Pin to align the thread
hole to the side hole on Clamp
Band.
Screw Clamp Tightening Bolt into
Pivot Pin.
To fix the clamp band firmly,
tighten the clamp side pin first
then tighten the pivot bolt later.
!
Do not tighten Pivot-
Pin Fixing Bolt firmly
yet. The next job will
become difficult.
Contact
MINOURA North America
(for U.S. residents only)
Hayward, Califormia, U.S.A.
Phone 1-510-538-8599 / Fax 1-510-538-5899
[email protected]
MINOURA Japan Headquarters
(for ALL customers)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone +81-584-27-3131 / Fax +81-584-27-7505
[email protected] / www.minoura.jp
Made in Japan
If you have questions or request, please contact the
shop where you originally purchased this product or the
distributor in your country first.
Only when you cannot get enough service from them,
you can contact us directly. However, please be sure we
don't sell any parts and product to consumer directly.
Get any necessary items through the authorized dealer.
Single arm
Dual arm