MINOURA BikeTower10 User Manual

Page 3

- 3 -

How To Install Bike Cradle

Bike Cradle is pre-installed
on each pillar and the
clamp band is temporally
tightened.
Change the clamp position

To change the clamp position, loosen BOTH Clamp
Tightening Bolt and Pivot-Pin Fixing Bolt
by the supplied M5 hex wrench, then slide gently.

Just loosening Clamp Tightning Bolt

should not work. Loosen BOTH bolts.

Top pillar is narrow and must require

Plastic Shim to be kept properly.

Do NOT remove the shim.

After changing the clamp position, tighten both
bolts firmly.

The lower clamp band touches the

pillar directly, so it may cause scratch

problem on pillar surface if you operate

roughly. Loosen widely.

Install the hooks to the pre-
assembled bike cradle arm. Attach the
hook from the foreside of Arm.

If it's hard to screw the arm connecting

bolt to the clamp, loosen both arm

fixing bolts on the back slightly and set

the arms horizontal. It allows to adjust

the bolt position correctly and will

Arms are independently angle adjustable in the
range of +/- 35 degrees in order to fit to various

We do not recommend you to set both

arms upright.

You should set Arm which supports

main load to horizontal or lower angle.

If the bolts are not firmly tightened,

Arms may move and cause the bike to

all off the hooks. Make sure the bolts

are tightened correctly.

to your favorite location after
extending Top Pillar.
Bike Cradle can be set at any
height and any angle on the pillar.

types of bike frame as
perfectly as possible.

Next, install the bike cradle to the clamp body.
Make sure there is a rectangle hole on the backside
of Base Plate. It will be connected to the clamp
body. Every load will be supported at this point.
Tighten Arm Connecting Bolt (hidden in the plastic
cap) through the center hole on Cradle Cap until
the bike cradle is rigidly installed.

make the job easier. Confirm you tighten both

bolts firmly after installation.

To change the arm angle, loosen Arm Connecting
Bolt through the center hole first, loosen the
backside fixing bolt on each arm, then change the
arm angle by hand.
After adjusting, make sure you tighten both center
and backside bolts firmly.