MINOURA B60-R / B60-D - Manual (Page 8)

If you wish to use the tire sized 26x1.0" or smaller,
you need to install the optional Z-shaped "Small
Wheel Adapter" between Base Plate and Mag unit
to raise up the roller height.
The direction of Z-adapter is fixed so follow
the arrow printed on the top and make sure it's
pointing toward the front (toward your bike).
If the drive roller cannot reach the tire even if
you install the adaptor, make sure you have been
installed in correct direction.
Use the original cap head bolts for the Base Plate,
and use the supplied hex head bolts for the Mag
unit.
How To Use Small Wheel Adaptor (Option)
Hex Head Bolt
Cap Head Bolt
Z-Adaptor
< Figure: in case of V270 >
Required Tools: 1 x 10mm Spanner
1 x M5 Hex Wrench
- Page 8 -
Why My Remote Shifter Doesn't Work Properly?
You may have a shifting problem that you cannot
set at L or H position properly due to the lengthened
inner cable.
To fix this problem, follow the steps to adjust the
initial cable tension.
1.
Set your remote shifter at "H" position and
remove the shifter from your handlebar, then
straighten the cable as much as possible.
2.
Pull out the plastic cover cap on foot of the
remote cable. (see Fig. P and R)
3.
Hold the inside adjusting screw and push it
toward the shifter, then adjust the locking nut to
set the cable tension properly. (see Fig. S)
4.
Check if the shifter lever can travel between L
and H correctly, especially when shifting to L.
Install the cover cap again.
(Fig. Q)
(Fig. R)
(Fig. S)
(Fig. T)