Specifying ip addresses for firewall rules, See specifying ip addresses for firewall, Rules(p. 233) – Canon i-SENSYS MF244dw User Manual
Page 239
Specifying IP Addresses for Firewall Rules
1525-04F
You can either limit communication to only devices with specified IP addresses, or block devices with specified IP
addresses but permit other communications. You can specify a single IP address or a range of IP addresses.
●
Up to 4 IP addresses (or ranges of IP addresses) can be specified for both IPv4 and IPv6.
●
The packet filters described in this section control communications over TCP, UDP, and ICMP.
1
Start the Remote UI and log on in System Manager Mode. Starting Remote
UI(P. 272)
2
Click [Settings/Registration].
3
Click [Security Settings] [IP Address Filter].
4
Click [Edit] for the filter type that you want to use.
Security
233
This manual is related to the following products: