Canon i-SENSYS MF244dw - Manual (Page 213)

Configuring Ethernet Settings
1525-040
Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication mode
(half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX). In general, the machine can be used without
changing the defaults ( Ethernet Driver Settings(P. 295) ), but you can change these settings to suit your network
environment.
1
Press .
2
Use / to select , and press .
● If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and press . Setting
the System Manager PIN(P. 228)
3
Select .
4
Select whether to configure Ethernet settings automatically or manually.
Configuring Ethernet settings automatically
Select , and press . The machine detects and automatically sets the communication mode and the
Ethernet type that can be used.
Configuring Ethernet settings manually
1
Select , and press .
2
Select the communication mode.
● Select select or .
Alternately sends and receives communication data. Select when the machine is connected to a
networking device using half duplex.
Simultaneously sends and receives communication data. Use this setting for most environments.
Network
207