Emerson Network Router - Manual (Page 8)

2 ProLink ® II Software for Micro Motion ® Transmitters
Before You Begin
1.2.2 Uses of ProLink II
Using ProLink II, you can:
• Perform initial transmitter startup procedures
• Read process variables
• Manage totalizers and inventories
• Configure the transmitter
• Perform verification and calibration procedures
• Read meter status information and alarm conditions
• Troubleshoot the meter
1.3 ProLink II requirements
Before starting the ProLink II installation, review the requirements in this section.
1.3.1 PC requirements
To install and run ProLink II, your PC must meet or exceed the following requirements:
• 200 MHz Pentium processor
• One of the following:
- Windows 2000 with Service Pack 3 and 128 MB RAM
- Windows XP with Service Pack 1 and 128 MB RAM
• 80 MB of available hard disk space
• Video with support for 256 or more colors
• CD-ROM drive
• An available serial port or USB port
1.3.2 Installation kits
Micro Motion provides ProLink II installation kits for RS-485 connections and for Bell 202
connections. There are four different kit options:
• RS-232 to Bell 202 HART converter with tester and cables
• RS-232 to RS-485 Modbus/HART converter with tester and cables
• USB to Bell 202 HART converter with tester and cables
• USB to Bell 202 HART converter with tester and cables
Note: A Windows driver is required for correct operation of USB converters and adapters. Drivers are
provided with the installation kit. Install the driver before connecting the converter or adapter. Failure
to install the driver first will result in Windows not recognizing the device when it is plugged in.