Emerson Network Router - Manual (Page 33)

Installation and Use Manual 27
Using ProLink II Software
Pr
oL
in
k II
Setup
T
ransmitter Star
tup
Usi
ng
Pr
oL
in
k
II
Be
fo
re
Y
o
u
Begin
Figure 3-1 Connect to Densitometer/Viscometer window
Making the connection – all other transmitters
1. Ensure that your PC is connected to a transmitter, using one of the methods described in
Chapter 2.
2. Choose Connection > Connect to Device . See Figure 3-2.
3. Select the protocol to use. Depending on the Protocol option that you choose, different
communications options will be available for configuration.
4. Specify Baud Rate , Parity , Stop Bits , COM Port , and Address/Tag as appropriate for your
connection and transmitter. See Section 2.6 for more information on these parameters.
5. If you are using the USB HART Interface, select Converter Toggles RTS .
6. Click Connect .
Alternately, if you do not know the address of your transmitter:
1. Click Poll . ProLink II will poll the network for all Micro Motion transmitters, and display a
list of all transmitters found.
2. Select the transmitter to connect to, and click OK.
Figure 3-2 Connection window (all other transmitters)