Emerson Network Router - Manual (Page 50)

44 ProLink ® II Software for Micro Motion ® Transmitters
Transmitter Configuration, Characterization, and Calibration
5.2.2 Loading a configuration file to a transmitter
To load a configuration file:
1. Choose File > Send to Xmtr from File .
2. Use the file dialog to locate the configuration file and click Open .
3. Click Upload Configuration .
4. When the load is complete, click Close .
If problems occur during the load:
1. Choose View > Preferences .
2. Select Error Log On .
3. Try to load the configuration file again.
ProLink II will now save an error log for the load process, and will display a message telling you
where to find the log file.
5.3 Configuring a transmitter
The procedures in this section provide a general method for configuring your transmitter using
ProLink II. Depending on the transmitter you are connected to, different tabs are displayed, and
different options are displayed on each tab.
For specific configuration information for your transmitter, refer to the transmitter manual.
Transmitter manuals are shipped with the transmitter, and are also available on the Micro Motion web
site (www.micromotion.com).
To configure a transmitter, choose ProLink > Configuration . See Figure 5-1.
Note: Before making changes to your transmitter’s configuration, be sure that you have saved the
configuration to a file as described in Section 5.2.