Emerson Network Router - Manual (Page 34)

28 ProLink ® II Software for Micro Motion ® Transmitters
Using ProLink II Software
Notes:
• Due to the design of HART protocol, connections made using HART protocol are slower than
connections that use Modbus protocol. If you use HART protocol, you cannot open more than one
ProLink II window at a time.
• If you are using HART protocol and a HART tag (software tag) has been configured for your
transmitter, you can specify the HART tag instead of the HART address.
• ProLink II can connect to only one transmitter at a time. To connect to another transmitter, you
must first disconnect from the current connection.
3.2.2 Disconnecting
To disconnect from the currently connected transmitter, choose Connection > Disconnect .
3.3 Using the Commissioning Wizard
When ProLink II first connects to a transmitter, the Commissioning Wizard appears (see Figure 3-3).
The Commissioning Wizard is a tool that guides you through the most common transmitter
configuration tasks.
Notes:
• If you have configured the Commissioning Wizard not to appear, you must choose Tools >
Commissioning Wizard to start the wizard.
• ProLink II does not preserve the task status of the wizard between sessions.
Figure 3-3 Commissioning Wizard