Epson RX620 - Manual (Page 43)

Scanning Film or Slides 43
Placing 35-mm Slides in the Holder
1. Fit the holder’s tabs into the two small holes at the rear edge of the glass.
Make sure the cutouts for 35-mm slides are in the middle of the glass (not at
the rear edge) to align them with the fluorescent lamp when you close the lid.
2. Place your slides in the film holder as shown.
Note:
The photos should be mirror-imaged when viewed from overhead. (The shinier
side faces down; the duller side faces up.)
To avoid unnecessary cropping of your photos, always place your slides with the
wider part of the film width-wise on the glass (in landscape orientation).
Continue with the steps on page 45 to scan and save your photos.
Cutouts for slides
are in middle of glass
Fluorescent lamp