Sealey VAG505 - Manual (Page 25)

23

If the manufacturer of your vehicle is not listed, use the
UP/DOWN scroll button to select Other and press the OK
button.
5.2 Erase Codes
CAUTION: Erasing the Diagnostic Trouble Codes may allow the
scan tool to delete not only the codes from the vehicle’s on-board
computer, but also “Freeze Frame” data and manufacturer
specific enhanced data. Further, the I/M Readiness Monitor Status
for all vehicle monitors is reset to Not Ready or Not Complete
status. Do not erase the codes before the system has been checked
completely by a technician.
NOTE: Erasing codes does not mean that trouble codes in
ECU have been eliminated completely. As long as there is
fault with the vehicle, the trouble codes keeps on presenting.
 This function is performed with key on engine off (KOEO). Do
not start the engine.
1) Use the UP/DOWN scroll buttons to select Erase Codes from
Diagnostics Menu and press the OK button. (Figure 5.3)
2) After you have pressed OK button, a message will come up
asking you to check the ignition and engine status. (Figure 5.6)
Figure 5.6
3. If you press Yes function key or OK button, a warning message
will come up asking your confirmation. (Figure 5.7)
Erase Codes
Ignition on and engine stopped?
Yes No .