Sealey TA070 User Manual
Anemometer, Ta070, Instructions for
1.1. General Safety
WARNING! Ensure Health & Safety, local authority and general workshop practice requirements are adhered to when using
this equipment.
WARNING! This equipment can be used in a wide variety of conditions and situations including workshop, industrial
and marine environments. In each case, the user of the equipment must familiarise themselves with the safety regulations
that apply to the particular conditions or situation in which the equipment will be used and do their own risk assessment in
order to stay safe and avoid personal injury.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip footwear.
Keep the anemometer clean and in good condition.
Protect the anemometer from solvents, acids or other aggressive substances.
Keep children and unauthorised persons away from the work area.
DO NOT get the anemometer wet or use in damp or wet locations or areas where there is condensation.
DO NOT use the anemometer for any purpose other than that for which it is designed.
DO NOT use the anemometer if any part of it is damaged.
DO NOT allow untrained persons to use the anemometer.
DO NOT use the anemometer when you are tired or under the influence of alcohol, drugs or intoxicating medication.
When not in use, clean the anemometer and store in a safe, dry, childproof area.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which cannot be built
into this product, but must be applied by the operator.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
2.1. Introduction
Wind speed measuring device featuring live/max/average/wind chill and Beaufort scale. Ideal for checking
workshop dust/fume extraction devices. Also reads temperature which can be measured in either °C or °F.
Readings are displayed on a 24mm high back-lit LCD screen. Features a battery indicator and auto/manual power
off. Requires CR2032 3V battery (supplied).
Original Language Version
TA070 Issue: 1 - 03/07/12
© Jack Sealey Limited 2012
INSTRUCTIONS FOR:
ANEMOMETER
Model No.
TA070
3. OPERATION
3.1. Switch On Procedure
3.1.1. Hold down the MODE button (fig1.1) for 2 seconds. The
unit will display the Air Velocity, Temperature and Battery
Condition. The screen backlight will illuminate for 12
seconds.
3.2. Setting the Unit of Measurement (Air Velocity)
3.2.1. With the unit switched on, hold down the MODE
button (fig.1.1) for 3 seconds until the 'm/s' symbol on
the display screen (fig.2) starts to flash.
fig.1
fig.2