Sealey VS8624 - Manual


WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are
strictly adhered to.
 DO NOT use the unit if it, or any attachment, is damaged.
 Maintain tester in good and clean condition for best and safest performance.
 If required, ensure that the vehicle to be worked on is adequately supported with axle stands or ramps and is
chocked.
 Put transmission in PARK (for automatic transmission) or NEUTRAL (for manual transmission) and make sure
the parking brake is engaged, or wheel chocks are in place.
 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.

Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
 WARNING! Use extreme caution when working around the ignition coil, distributor cap, ignition wires and spark
plugs. These components create hazardous voltages when the engine is running.
 DO NOT connect or disconnect any test equipment with ignition on or engine running.

Keep a fire extinguisher nearby, which is suitable for gasoline/chemical/electrical fires.

Account for all tools and parts being used and do not leave any in the engine bay.
 Keep reset tool dry, clean and free from oil, water and grease. Use a mild detergent on a clean cloth to clean
the outside of the tool.
 Operate the vehicle in a well-ventilated work area; exhaust gases are poisonous.
IMPORTANT: Always refer to the vehicle manufacturer’s service instructions to establish the current procedure
and data. These instructions are provided as a guide only.
 WARNING! The warnings and instructions discussed in this manual cannot cover all possible conditions
and situations that may occur. It must be understood that common sense and caution are factors which
cannot be built into this product, but must be applied by the operator.
Essential tool for extinguishing the service indicator and resetting Electronic
Parking Brake on Land Rover and Range Rover vehicles. Simple push button
operation allows EPB cable to be released and re-attached and, in the event
that the emergency hand brake has been activated, allows the user to reset
the system, and clears codes that may have been generated as a result of the
emergency cable being pulled. It also allows the EPB to be un-jammed when
the vehicle has entered a state of brake screech when applying the parking
brake, where the rear brakes squeak or rub when the vehicle is moving or
there is evidence of shoe-drag. Powered by connection to the vehicle.
INSTRUCTIONS FOR:
SERVICE INDICATOR & EPb RESET
TOOL - LAND ROVER / RANGE ROVER
MODEL No: VS8624
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION
Original Language Version
VS8624 Issue: 1 - 16/07/10
TECHNICAL HELP LINE No. 01284 757505
Please register your product with Sealey by completing the registration form on-line at www.sealey.co.uk
Navigate to Register Product. By registering your product you can take advantage of Sealey product and technical
updates via email.