Enviro EA800 User Manual
Enviro Safety
Table of contents
Document Outline
- Table of Contents
- General Information
- Preparation
- Installation
- Tools and Supplies Required
- Power Requirements
- Mounting the EA800 Rear Plate
- Install the Wired Sensors
- EA800 Base Unit Power Connections
- Install the Wireless Sensors
- Connecting Wired Temperature, Contact Closure, and Water Bug Sensors
- Connecting Wired HA-III+ Humidity Sensors
- Connecting Wired 4-20mA Sensors
- Connecting the EA800 Alarm Outputs
- Programming
- Adding Wireless Sensors
- Adding a Wireless Temperature Sensor
- Adding a Wireless Multi-Function Sensor Using a Wired Temperature Sensor
- Adding a Wireless Humidity Sensor
- Adding a Wireless Multi-Function Sensor Using a Wired WaterBug Sensor
- Adding a Wireless Multi-Function Sensor Using a Wired Contact Closure Sensor
- Verify Wireless Signal Strength
- Adding Wired Sensors
- Configuring the Relays
- Operation
- Maintenance
- Locking and Unlocking the EA800
- Pausing Monitoring and Cancelling Pause
- Adding a Sensor
- Replacing a Sensor
- Editing Sensor Parameters
- Reprogramming a Relay
- Deleting a Sensor
- Changing the Date Format
- Changing the Time Format
- Changing the Date or Time Setting
- Changing Sensor Data Collection Frequency
- Changing the Buzzer Setting
- Changing the Password
- Clearing the Alarm Log
- Clearing the Sensor Log
- Updating the Firmware
- Saving Configuration Settings
- Loading Configuration Settings
- Exporting the Stored Logs
- Troubleshooting
- Specifications
- Appendix A: Screen Maps
- Appendix B: Planning Worksheet
- Appendix C: Wiring Diagram
- Appendix D: System Configuration Record
- Warranty and Service Information