Epson VIGOR 3300 - Manual (Page 44)

Vigor3300 Series User’s Guide 40
Host Name Some ISP may ask you to type your host name. Please type in if
necessary.
Domain Name Some ISP may ask you to type your domain name. Please type
in if necessary.
Detect Type Select a detecting type for this WAN interface. There are three
ways Send ARP to Gateway, Send PING and Send HTTP
Request supported in 3300.
Detect Interval (sec) Assign an interval period of time for each detecting. The
minimum value is 3 and no limit for maximum value.
No-Reply Count Assign detecting times to ensure the connection of the WAN.
After passing the times you set in this field and no reply
received by the router, the connection of WAN interface will be
regarded as breaking down.
Detect Destination Host
(IP or Domain Name)
Assign an IP address or Domain name as a destination to be
detected whether the host is active (sending reply to the
router) or not. If not, the connection of WAN interface will be
regarded as breaking down. This function is available when
Detect Type is set with Send PING or Send Http Request.
IP Alias List Sets other IP addresses binding in this interface. You can set up
to 32 sets of IP alias settings. If you have typed addresses here,
you can see and choose it in later web page settings (e.g.,
Advanced >> NAT>>Port Redirection/DMZ Host).
Apply Click Apply to go back to the WAN Interface Configuration
page. To apply all settings, click Apply on the WAN Interface
Configuration page and reboot your router.
Reset Click this button to clear all the configurations for this page.