Extron Electronics RGB 168xi User Manual
Page 9

RGB 168xi
xi
xi
xi
xi • Introduction
devices such as LCD projectors, DLP projectors and
plasma displays. A rear panel DIP switch allows an
alternative, Digital Display Sync Processing
™
(DDSP
™
), to be used instead.
Gain/peaking control
— To compensate for signal
degradation caused by long cable lengths, use this
rear panel toggle switch to increase output voltages.
Serration pulse
— This feature allows serration pulses to
either be present or not present at the output.
Serration pulses are required for some displays.
Pass-through connectors
— A wide assortment
of architectural adapter plates is available for
installation on these interfaces to allow convenient
pass-through A/V connections.
Buffered local monitor output
— A 15-pin HD female
connector provides a front panel buffered output for
a local monitor.
ID bit termination
— Two front panel DIP switches
provide ID bit termination on pins 4 and/or 11 of the
local monitor output.
1-3