Extron Electronics RGB 168xi - Manual (Page 12)

RGB 168xi xi xi xi xi • Installation and Operation
Installation and Operation, cont’d Installation and Operation
Installation Overview
To install and set up the RGB 168xi for operation, follow
these basic steps:
1 Turn all of the equipment off. Make sure that the
computer, the interface and the output device(s)
(projector or display monitor, and local monitor) are
all turned off and disconnected from the power
source.
2 Set internal jumpers for sync polarity and sync pulse
width. See “Setting Internal Jumpers” in this chapter.
3 Install optional adapter plates for pass-through A/V
connections. See “Installing Adapter Plates” in this
chapter.
4 Install the rubber feet for tabletop use, or install the
appropriate brackets and furniture or rack mount the
interface. See “Mounting the Interface” in this
chapter.
5 Attach the input (computer) and output (display, local
monitor and audio) cables. See “Cabling” in this
chapter.
6 Set the DIP and toggle switches. Use the “Front
Panels” and “Rear Panels” sections of this chapter as
a guide.
7 Connect power cords and turn on the devices in the
following order: output devices (projector, monitors,
speakers) and input device (computer).
8 The image should appear on screen, and sound
should be audible. If not, ensure that all devices are
plugged in and receiving power. Check the cabling
and switch settings, and make adjustments as
needed.
Refer to “Troubleshooting” in this chapter, then call
the Extron customer support hotline, if needed.
2-2