Extron Electronics RGB 168xi - Manual (Page 24)

RGB 168xi xi xi xi xi • Installation and Operation
Installation and Operation, cont’d
RGB 168 xi
INPUTS
AUDIO
ANALOG
UNSWITCHED
600 W ATTS MAX.
MIN/MAX
UNIVERSAL INTERF
ACE W /ADSP
ID PIN 14 ID PIN 11
BUFFERED LOCAL
MONIT OR OUTPUT
Under-desk mounting
Through-desk mounting
1 . Attach the Extron MBD 149 through-desk mounting
brackets (part #70-077-03) to the interface with the
provided machine screws.
2 . Hold the interface with attached brackets against the
underside of the mounting surface of the desk or table.
With a soft pencil mark the location of holes for screws
on the desk. Mark the opening, approximately 17.63" x
1.88" (44.77 cm x 4.76 cm).
3 . Cut out the material from the installation area with a
jigsaw. Check the opening size by inserting the
interface part way through the hole. If needed, use a
saw, file or sandpaper to enlarge the hole. Smooth the
edges of the hole with sandpaper.
4 . Drill 1/4" (6.4 mm) deep, 3/32" (2.38 mm) diameter pilot
holes in the desk or table at the marked screw locations.
The holes should be drilled from the underside or inside
(concealed side) of the furniture, where the interface will
be located.
5 . Attach the interface to the desk with the provided wood
screws, as shown in the following illustration.
2-14