Yaskawa Varispeed-656 DC5 - Manual (Page 39)

3 WIRING
E-29
* 1. Indicates the terminal number of the control card.
* 2. The input signals excluding RUN-SB signal are status signals. (RUN-
SB signal is a rising trigger signal and held internally.) When RUN-
SB and fault reset signals are input, the input must be held at least 40
ms.
Photocoupler
Output
25 - 27 Multi-function
Photocoupler
Open-collector
Output
Set to “CREADY (Converter
Ready)” prior to shipment. 48 VDC 80
mA or less
26 - 37 Set to “MC Operating (MCON)”
prior to shipment.
Relay Output 18 - 20
19 - 20 FAULT Output
(Transfer Contact)
Outputs when a fault is detected.
Terminal 18-20: Closed during fault
detection
Terminal 19-20: Open during fault
detection
250 VAC 1 A
or less
30 VDC 1 A
or less
9 - 10 Multi-function
Contact Output
Set to “During Converter Running
(During Run)” prior to shipment.
Analog Output 21 Multi-function
Analog Output
Set to “Input power (AC Side
Power)” prior to shipment. -10 V to +10
VDC or less
23 Set to “Input current (Input Cur-
rent)” prior to shipment.
22 Multi-function
Analog Common
−
Table 7 Control Circuit Terminal Functions (cont’d)
Terminal Name *1 Signal Name Function Signal Level