Yaskawa P7 to P1000 - Manual (Page 41)

13 Appendix 2 Parameter Cross Reference
YASKAWA PL.P1000.01 P7 to P1000 - Product Transition Guide 41
Motor
Protection
Function
Motor Overheat
Fault Operation
Selection
L1-04 1 L1-04 1
L1-04 L1-04
0: Ramp to stop 0: Ramp to stop
1: Coast to stop 1: Coast to stop
2: Fast Stop 2: Fast Stop
Motor
Temperature
Input Filter Time
L1-05 0.20 s L1-05 0.20 s —
Momentary
Power Loss
Process
Momentary
Power Loss
Detection/
Operation
Selection
L2-01 2 L2-01 2
L2-01 L2-01
0: Disabled 0: Disabled
1: Power Loss Ride Thru Time
1: Recover within the
time set in L2-02
2: CPU Power Active
2: Recover as long as
CPU Power Active
—
3: KEB deceleration for
time set in L2-02
—
4: KEB deceleration as long as
CPU has power.
— 5: KEB deceleration to stop.
Momentary
Power Loss
Ride-Thru Time
L2-02 * L2-02 **
*Dependent on duty rating parameter C6-01 and drive capacity
parameter o2-04.
**Dependent on drive capacity parameter o2-04
Momentary
Power Loss
Minimum
Baseblock Time
L2-03 * L2-03 **
*Dependent on duty rating parameter C6-01 and drive capacity
parameter o2-04.
**Dependent on drive capacity parameter o2-04
Momentary
Power Loss
Voltage
Recovery Ramp
Time
L2-04 * L2-04 **
*Dependent on duty rating parameter C6-01 and drive capacity
parameter o2-04.
**Dependent on drive capacity parameter o2-04
Undervoltage
Detection Level
L2-05 190 V L2-05 190 V
380 V for a 400 class drive.
If E1-01 is set lower than 400, set 350 V for P1000.
Stall
Prevention
Function
Stall Prevention
Selection during
Acceleration
L3-01 1 L3-01 1
L3-01 L3-01
0: Disabled 0: Disabled
1: General purpose 1: General purpose
2: Intelligent 2: Intelligent
Stall Prevention
Level during
Acceleration
L3-02 120%* L3-02 120% **
*Varies by duty rating parameter C6-01
**Upper limit is determined by L8-38.
Stall Prevention
Selection during
Deceleration
L3-04 1 L3-04 1
L3-04 L3-04
0: Disabled 0: Disabled
1: General purpose 1: General purpose
2: Intelligent 2: Intelligent
—
3: Stall Prevention with
braking resistor
— 4: Overexcitation Deceleration
— 5: Overexcitation Deceleration 2
Stall Prevention
Selection during
Run
L3-05 1 L3-05 1
L3-05 L3-05
0: Disabled 0: Disabled
1: Enabled
(Decel Time 1)
1: Enabled (Decel Time 1)
2: Enabled
(Decel Time 2)
2: Enabled (Decel Time 2)
Parameter Name
P7 P1000 Setting
Parameter Default Parameter Default P7 P1000