SMA SB 3000TL-20 Installation - Manual (Page 71)

SMA Solar Technology AG Messages
Installation Guide SB30TL_40TL_50TL-IA-IEN120231 71
10 Messages
10.1 Event messages
During an update, the relevant display message is shown in the text line of the display.
No display in the event of insufficient DC voltage
Measurements and the issuing of messages are only possible when there is sufficient DC
voltage.
Display Description
< Avvio Autotest > Only relevant for an installation in Italy: start the self-
test by tapping on the display according to DK 5940
(see section 6.3 ”Self-Test in accordance with DK
5940, Ed. 2.2 (Applies to Italy Only)” (page 55)).
< Inst. code valid > The SMA guard grid code entered is valid.
The configured country data set is now unblocked
and can be changed.
If the configured country data set is protected, the
unlocking is valid for a maximum of 10 feed-in hours.
< No new update SDcard > There is no update file relevant for this inverter on the
SD card or the available update has already been
carried out.
< Grid param.unchanged > The selected switch setting is not programmed or
there is no country data set available on the SD card.
< Parameters set successfully > A new country data set has been configured.
< SD card is read > The inverter is currently reading the SD card.
< Set parameter > The inverter sets the parameters.
< Update completed > The inverter has successfully completed the update.
< Update Bluetooth > Successful update of the Bluetooth components.
< Update display > Successful update of display.
< Update main CPU > Successful update of inverter component.
< Update communication > Successful update of communication component.
< Update RS485I module > Successful update of communication interface.
< Upd. language table > Successful update of language table.
< Update file OK > The update file found is valid.