SMA SB 3000TL-20 Installation - Manual (Page 37)

SMA Solar Technology AG Electrical Connection
Installation Guide SB30TL_40TL_50TL-IA-IEN120231 37
4. Push the threaded joint to the thread and screw into place with a torque of 2 Nm.
☑ The DC connectors are now assembled and can be connected to the inverters, as described in
section 5.4.5 ”Connecting the PV Generator (DC)” (page 39).
☑ If the conductors are not visible in the
hollow cavity, the cable is not in the correct
position.
• Loosen the clamping bracket with the help
of a screwdriver. The width of the
screwdriver should be 3.5 mm.
• Remove cable and start again from step 1.
Result Measure