SMA SB 1200 Installation - Manual (Page 31)

SMA Solar Technology AG Electrical Connection
Installation Guide SB12-17-IA-en-52 31
4. Push the threaded joint to the thread and screw into place with a torque of 2 Nm.
☑ The DC plug connectors are now assembled and can be connected to the inverters, as
described in section 5.4.4 ”Connecting the PV Generator (DC)” (page 33).
☑ If the conductors are not visible in the
hollow cavity of the clamp, the cable is not
in the correct position.
• Declamp the clamping clip. Use a
screwdriver with a width of 3.5 mm.
• Remove cable and start again from step 1.
Result Action