SMA SPEEDWIRE V.1.6 - Manual (Page 13)

SMA Solar Technology AG 4 Product Description
Installation Manual SWWEBCONDM-IA-en-16 13
Label with PIC and RID for registration of a small-scale PV system in Sunny Portal
To activate the Speedwire/Webconnect data module of a small-scale PV system in Sunny Portal, you
will need the PIC and RID numbers printed on the label included in the delivery. After installation of
the Speedwire/Webconnect data module, a label should be attached to the exterior of the inverter
in the vicinity of the type label. Keep the other label in a safe place for future reference.
4.2 Possible Network Topologies
The possible network topologies depend on the devices used and on the number of network ports.
The Speedwire/Webconnect data module has two network ports. For further information on network
topologies, refer to the Technical Information "SMA Speedwire Fieldbus" at www.SMA-Solar.com.
4.3 Type Label
The type label clearly identifies the product. The type label is located in the right-hand top corner on
the front of the product. You can read the following data from the type label:
• Device type (Type)
• Serial number (Serial No.)
• Hardware version (Version)
• PIC
• RID
• MAC address (MAC Address)
You will require the information on the type label to use the product safely and when seeking customer
support from the SMA Service Line.
Position Designation
A Hexagon socket screw (AF 3)
B Network port A
C Network port B
D Ribbon cable plug
E Ribbon cable
F Type label