SMA SPEEDWIRE V.1.6 - Manual (Page 10)

2 Safety SMA Solar Technology AG
10 SWWEBCONDM-IA-en-16 Installation Manual
2.4 Supported Products
SMA inverter
The Speedwire/Webconnect data module must only be installed in the following SMA inverters from
the indicated inverter firmware version:
Additional SMA Products
The Speedwire/Webconnect data module can be configured with the following communication
products:
• SMA Cluster Controller from firmware version 1.0
• Sunny Explorer from software version 1.06
• SMA Connection Assist from software version 1.00.8.R
Sunny Explorer and SMA Connection Assist are available free of charge at www.SMA-Solar.com.
SMA Inverter*
* For information on which of these SMA inverters with Speedwire/Webconnect data module supports the Modbus interface
of the Speedwire/Webconnect data module, see the datasheet "SMA_Modbus-DB-en.xlsx" at www.SMA-Solar.com.
From inverter firmware version
SB 2500TLST-21
SB 3000TLST-21 2.53**
** If the firmware version of the inverter is lower than 2.53, you must perform a firmware update to version 2.53 or higher for
this inverter. For information on performing the firmware update, refer to the Technical Description "Firmware Update with
SD Card" at www.SMA-Solar.com.
SB 3000TL-21
SB 3600TL-21
SB 4000TL-21
SB 5000TL-21
SB 6000TL-21
STP 8000TL-10
STP 10000TL-10
STP 12000TL-10
STP 15000TL-10
STP 17000TL-10
STP 15000TLEE-10
STP 15000TLHE-10
STP 20000TL-30
STP 25000TL-30
all
STP 20000TLEE-10
STP 20000TLHE-10 2.53**