SMA FLX Series - Manual (Page 7)

1 Introduction
1.1 Purpose of the Manual
The Installation Guide provides information required to
install and commission the FLX series inverter.
Additional resources available:
• User Guide, for information required in monitoring
and setup of the inverter, via the display or web
interface.
• Design Guide, for information required for
planning use of the inverter in a diversity of solar
energy applications.
• Sensor Interface Option Installation Guide, for
installation and commissioning of the sensor
interface option.
• GSM Option Kit Installation Guide, for information
required to install a GSM option, and set up data
upload or messaging from the inverter.
• PLA Option Guide, for information required to
install and set up PLA option for connecting radio
ripple control receiver to the inverter.
• Fan Installation Instruction, for information
required to replace a fan.
These documents are available from the download area at
www.SMA.de, or from the supplier of the solar inverter.
Illustration 1.1 FLX Series Inverter
The FLX series inverters feature:
• IP65 enclosure
• PV load switch
• Sunclix connectors for PV input
• Manual access via the display, for configuration
and monitoring of the inverter.
• Ancillary service functionalities. Refer to the FLX
Series Design Guide for details.
• Access via web interface, for configuration and
monitoring of the inverter.
1.2 Software Version
This manual is applicable for inverter software 2.05 and
onwards. To see the software version, via the display or
web interface (inverter level), go to [Status
→ Inverter →
Serial no. and SW ver.
→ Inverter].
NOTICE
Software version at manual release is 2.05. Information
about current software version is available at
www.SMA.de.
Introduction
6 L00410568-03_2q / Rev. date: 2014-06-20
1 1