HEIDENHAIN TNC 640 (34059x-01) Cycle programming - Manual (Page 296)

296 Cycles: Turning
13.7 TURN, L
O
NGITUDIN
AL PLUNGE (Cy
c
le 813)
Cycle parameters
U Machining operation Q215: Define the machining
operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing to finished dimension
3: Only finishing to oversize
U Set-up clearance Q460 (incremental): Distance for
retraction and pre-positioning
U Diameter at contour start Q491: X coordinate of the
starting point for the plunging path (diameter value)
U Contour start in Z Q492: Z coordinate of the starting
point for the plunging path
U Diameter at end of contour Q493: X coordinate of
the contour end point (diameter value)
U Contour end in Z Q494: Z coordinate of the contour
end point
U Angle of side Q495: Angle of the plunging side. The
reference angle is formed by the perpendicular to the
rotary axis.
U Maximum cutting depth Q463: Maximum infeed
(radius value) in radial direction. The infeed is divided
evenly to avoid abrasive cuts.