HEIDENHAIN TNC 640 (34059x-01) Cycle programming - Manual (Page 280)

280 Cycles: Turning
13.1 T
u
rn
ing Cy
cles (Sof
tw
ar
e
O
ption
50)
13.1 Turning Cycles
(Software Option 50)
Overview
Defining turning cycles:
U The soft-key row shows the available groups of
cycles
U Select the menu for cycle group TURNING
U Select cycle group, e.g. cycles for longitudinal turning
U Select cycle, e.g. TURN SHOULDER, LONGITUDINAL
The TNC offers the following cycles for turning operations
:
Cycle group Cycle Soft key Page
Special cycles
ADAPT ROTARY COORDINATE SYSTEM (Cycle 800) Page 283
RESET ROTARY COORDINATE SYSTEM (Cycle 801) Page 285
Cycles for longitudinal turning Page 286
TURN SHOULDER, LONGITUDINAL (Cycle 811) Page 287
TURN SHOULDER, LONGITUDINAL EXTENDED (Cycle
812) Page 290
TURN, LONGITUDINAL PLUNGE (Cycle 813) Page 294
TURN, LONGITUDINAL PLUNGE EXTENDED (Cycle 814) Page 298
TURN CONTOUR, LONGITUDINAL (Cycle 810) Page 302
TURN CONTOUR-PARALLEL (Cycle 815) Page 306