HEIDENHAIN iTNC 530 (34049x-08) - Manual (Page 727)

HEIDENHAIN iTNC 530 727
1
9
.4 Specifics about file manag
e
ment
19.4 Specifics about file
management
The iTNC drive
When you call the iTNC file manager, the left window shows all
available drives. For example:
 C:\ : Windows partition of the built-in hard disk
 RS232:\ : Serial interface 1
 RS422:\ : Serial interface 2
 TNC:\ : Data partition of the iTNC
There might also be other networks available if you have connected
them with Windows Explorer.
If you connect a new network drive with Windows Explorer, you may
have to update the iTNC’s display of available drives:
 Press the PGM MGT key to call the file manager
 Move the highlight to the drive window at left
 Switch to the second level of the soft-key row
 To update the drive overview, press the UPDATE TREE soft key
Please note that the data drive of the iTNC appears in the
file manager with the name TNC:\. In Windows Explorer,
this drive (partition) appears with the letter D.
Subdirectories on the TNC drive (e.g. RECYCLER and SYSTEM
VOLUME IDENTIFIER
) are created by Windows XP and may
not be deleted.
With MP7225 you can define letters of drives that should
not be shown in the file management of the TNC.