HEIDENHAIN iTNC 530 (34049x-08) - Manual (Page 53)

HEIDENHAIN iTNC 530 53
12.5 Miscellaneous functions for rotary axes ..... 506
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 506
Shorter-path traverse of rotary axes: M126 ..... 507
Reducing display of a rotary axis to a value less than 360°: M94 ..... 508
Automatic compensation of machine geometry when working with tilted axes: M114 (software option 2) ..... 509
Maintaining the position of the tool tip when positioning with tilted axes (TCPM):
M128 (software option 2) ..... 511
Exact stop at corners with nontangential transitions: M134 ..... 514
Selecting tilting axes: M138 ..... 514
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 515
12.6 Three-dimensional tool compensation (software option 2) ..... 516
Introduction ..... 516
Definition of a normalized vector ..... 517
Permissible tool shapes ..... 518
Using other tools: Delta values ..... 518
3-D compensation without tool orientation ..... 519
Face milling: 3-D compensation with and without tool orientation ..... 519
Peripheral milling: 3-D radius compensation with workpiece orientation ..... 521
3-D tool radius compensation depending on the tool’s contact angle (3D-ToolComp software option) ..... 523
12.7 Contour movements – Spline interpolation (software option 2) ..... 527
Application ..... 527