New functions in version 34049x-07 – HEIDENHAIN iTNC 530 (34049x-08) User Manual
Page 21
New functions in v
e
rsion 34049x
-07
HEIDENHAIN iTNC 530
21
New functions in version 34049x-07
Improvement of Dynamic Collision Monitoring (DCM):
Chucking equipment archives can now be activated (see "Loading
fixtures under program control" on page 415) and deactivated (see
"Deactivating fixtures under program control" on page 415) under
program control
The display of stepped tools has been improved
Extension of the functions for multiple axis machining:
In the Manual Operation mode you can now move the axes even
if TCPM and Tilt Working Plane are active at the same time
You can now also change tools when M128/FUNCTION TCPM is active
File management: archiving of files in ZIP archives (see "Archiving
files" page 146 ff)
The nesting depth for program calls has been increased from 6 to 10
(see "Nesting depth" on page 297)
smarT.NC units can now be inserted anywhere in plain-language
programs (see "smartWizard" on page 455)
There is now a search function based on tool names available in the
tool selection pop-up window (see "Search for tool names in the
selection window" on page 196)
Improvements in pallet machining:
The new column FIXTURE has been added to the pallet table to be
able to activate fixtures automatically (see "Pallet operation with
tool-oriented machining" page 538 ff)
The new workpiece status SKIP has been added to the pallet table
(see "Setting up the pallet level" page 544 ff)
If a tool sequence list is created for a pallet table, the TNC now
also checks whether all the NC programs of the pallet table are
available (see "Calling the tool management" on page 203)
The new host computer operation was introduced (see "Host
computer operation" on page 685)